300e Flex disc question?
I just replaced my engine over the weekend and when I took my test drive I noticed a clunking noise during shifts. After inspection I noticed play in the front Flex disc and thought it to be bad. After a forum search, I saw someone say they are only bad if the are cracking.
My question is, is there suppose to be any play or should it be snug? When I turn the drive shaft I can see the bolts in the disc move side to side. Any feedback would be helpfull. Thanks, Jim |
snug....
with no play. Bolts may need to be tightened or the bolt holes are 'ogwallered', hopefully only in the disc itself.
the bern |
When fitting the flex disk, there are metal bushings that the bolts go through. These must be seated up in a lip in the transmission and driveshaft yoke. If you completely removed the flex disk from both driveshaft AND transmission yoke, then you got it in 60 degrees off.
Good luck, |
just make sure you dont put the disk in backwards like i did. :rolleyes:
|
1 Attachment(s)
Here is what happens if you do....
|
All times are GMT -4. The time now is 04:53 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website