|
|
|
#1
|
||||
|
||||
Hydraulic Ram for Shop Press
hello
this isn't on mbz topic but it is an automotive tool and this forum the folks seem to be very knowledgeable on most topics. i'm looking for an hydraulic ram. i'm making a large shop press. i am looking for a minimum stroke of 12.0" but actually would like a 14" stroke. my first use is for a broaching set up. my second use is for a brake operation. the tonnage i am looking for will be a minimum 20 ton. i am also looking for a pump package with an electric motor any voltage single or three phase. used equipment is fine probably preferred over new. tks craig
__________________
Thanks Much! Craig 1972 350sl Red/Blk 117k 1988 420sel charcoal/Blk 140k 1987 420sel gold/tan 128k See My Cars at:http://mysite.verizon.net/res0aytj/index.html Pound it to fit then Paint it to match! There is only First Place and Varying degrees of last! Old age and deceit will overcome Youth and Enthusiasm every time! Putting the square peg in the round hole is not hard... IF you do it fast enough! Old enough to know better but stupid enough to do it anyway! |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|