|
|
|
#1
|
|||
|
|||
I need to change my motor mounts on a 1975 230 sedan. All three bolts are only accessible from the top of the mount. The problem is I would have to lift the engine up with a floor jack a few inches for the clearance I would need. It this a problem? Should I only remove one at a time as I do not know if this would allow me to lift the engine as much as I need. Alsoo what size hex socket is use ther is two on each mount and are monuted top to bottom.
All help or suggestions appreciated. Thanks, Chris |
#2
|
|||
|
|||
Instead of beeing the 55th person to awnser the same guys question how about beeing the first on these post to awnser? The first pg is full of guys with no response.
|
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
83 300CD tranny modulator question | freesprung | Tech Help | 0 | 04-07-2004 10:10 PM |
Trouble Codes Question | talons40 | Tech Help | 2 | 08-22-2003 02:36 PM |
Center Console Question | hippie_elmo | Vintage Mercedes Forum | 2 | 02-01-2002 11:47 PM |
190E tire question | cossie | Mercedes-Benz Wheels & Tires | 14 | 01-31-2002 05:49 PM |