|
|
|
|
|
#1
02-11-2001, 12:06 PM
|
|||
|
|||
|
Two questions concerning a 1999 ML 320 brake pad replacement. 1) Will replacing the pads be routine? Any special tools required? 2) How does the low brake pad indicator on dash work. It has flashed on and off several times but does not stay on.On other models they have a sensor that once it is set off needs to be replaced.I don t believe this is the same system. Thanks for any tips. Mark
[Edited by cerbomark on 02-11-2001 at 07:40 PM]
__________________
98 E430(sport), 99 ML 320 (sold) , 05 C 230(sport) Mark 
|
|
#2
02-11-2001, 02:57 PM
|
||||
|
||||
|
I would do a visual inspection of the brake pads. You might be able to get up to 3k miles out of that set of pads. As you read this, the light might be coming on a little more often. Changing the pads requires only some simple tools and a #40 torx bit.
Kuan
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| front brake pad sensors for c200-1997 | sunil190e-1.8 | Tech Help | 2 | 05-03-2004 01:42 PM |
| Replacing brake rotors and pads on a 95 E320 W124 - first time DIY observations | 71Rcode | Tech Help | 11 | 03-10-2004 01:00 PM |
| E420 w/ brake rotor @ 23mm & pad @ 10% | DuckMuck | Tech Help | 0 | 05-07-2003 05:56 PM |
| Brake Pad warning light - Other causes | tivoliman | Tech Help | 5 | 02-24-2003 10:03 AM |
| Are there W202 cars without brake pad wear sensors? | blackmercedes | Tech Help | 3 | 01-11-2003 02:09 PM |
Linear Mode
