88 300E Heater problem Fixed!!
Hey Everyone!
A while back I wrote that I had heat coming out of all my vents at all times. Turns out I had a stuck monovalve! Here's how I tested it; 1. Got a volt meter, and tested input voltage going to valve. The voltage test 12 volts completely cold, and alternated between 6 and 12 until completely open where it registered about .6. 2. Created a jumper that went directly from the battery to the valve. With 12 true volts, it was still open. Replaced the valve and all was good. I just replaced it today, so I will follow up in a few days with a status! Thanks for all the help! Mike |
All times are GMT -4. The time now is 11:48 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website