|
|
|
|
|
#1
06-22-2000, 08:59 AM
|
|||
|
|||
|
would like to find out if there is an over-voltage relay in a W123? If so, where? Also, where is the voltage regulator, if there's one. Thanks!
|
|
#2
06-22-2000, 09:07 AM
|
|||
|
|||
|
Voltage reg/brush assembly is mounted on back of alternator with two screws; 'can be removed and replaced with short, common screwdriver in less than five min. Remove two screws, pull the small unit down and to rear while jiggling it slightly and carefully to clear lower edge of the alt. Replacement is reverse of removal.
------------------ Wilton Strickland Goldsboro, NC 91 350 SDL. 81 300D
|
 |
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 1987 Mercedes 190e 2.3 and Overvoltage Protection Relay | Eidetic57 | Tech Help | 3 | 12-13-2004 12:07 PM |
| Bizzarro Overvoltage relay problem | classic69 | Tech Help | 6 | 10-11-2003 08:38 PM |
| Won't start cold-blows fuse on new overvoltage relay | rradeski | Tech Help | 0 | 11-14-2001 08:51 PM |
| Overvoltage Protection Relay Failure Modes | Telerding | Tech Help | 1 | 10-19-2001 12:17 AM |
| Another question about weird idle & overvoltage relay | Karl226 | Tech Help | 4 | 02-20-2001 08:53 AM |
Linear Mode
