PeachParts Mercedes-Benz Forum

PeachParts Mercedes-Benz Forum (http://www.peachparts.com/shopforum/)
-   Tech Help (http://www.peachparts.com/shopforum/tech-help/)
-   -   Wanting to purchase a 94-95 E320 wagon.......... (http://www.peachparts.com/shopforum/tech-help/90749-wanting-purchase-94-95-e320-wagon.html)

tulah 05-31-2007 06:33 AM

anyone have a transmission issues?



I just bought a 1995 with 228K. All service history from new 1 owner .
Pretty much everything mentioned has been replaced or rebuilt at some point.

Anyone have any Transmission problems?
I've noticed that when shifting from 1st to 2nd (around 15mph) the car "kicks". from 2nd to 3rd gear it "hesitates" to shift for like a second then when it doe's shift it"kicks" harder( car rocks a bit) .
However when I shift it with the pedel(ease off the gas when I expect the tranny to shift) the "kicking" is not too bad.
Are these signs of the tranny on it's way out?
would a bad transmission mount cause this?
Anyone have this issue or something similar?
What should I expect to pay?

Thanks,
Tony

BTW
I absolutely love this car. great ride, comfy roomy interior, stylish body. ETC

J. M. van Swaay 05-31-2007 06:19 PM

My 94 E320 Wagon just turned over 200,000 miles. It is a fantastic car--I intend to drive it at least another 100,000 miles. The interior still looks like it did when it rolled of the assembly line, and the performance rivals many new cars I have riden in or driven. Having said all this, I would still only recommend this car if you are a DIYer or don't mind paying for expensive maintenance. Here's my list....

wiring harness DIY
head gasket DIY
rear suspension accumulators DIY
blower motor DIY
EGR tube DIY
temp sensor for climate control DIY
AC evaporator DIY
belt tensioner DIY
ignition coils DIY
ignition wires DIY
smog pump (rebuild) DIY
throttle actuator rewire DIY
brakes DIY
radiator DIY
steering tie rods DIY
and of course all the routine stuff...

One of the previous posts mentioned multiple head gasket failures. There are at least two different manufacturers of head gaskets. Only one has the reinforcement that prevents leaks at the right front corner. If a gasket was replaced with the non reinforced one, it will fail again.....Also, I think the wire harness is more in the $800 range for just the part.

J. M. van Swaay


All times are GMT -4. The time now is 04:53 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website