Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help




Go Back   PeachParts Mercedes ShopForum > Technical Information and Support > Tech Help

Reply
 
LinkBack Thread Tools Display Modes
  #1  
Old 08-24-2000, 01:14 AM
ralfmalph
Guest
 
Posts: n/a
When u get the head off carefully clean the tops off of all the pistons in an area close to the edge and indexed at the same place on each piston.Use a vacuum cleaner to catch the debris. Bring each piston to TDC w/ a dial indicator ( careful of the T-chain during all that turning). Using a depth mic, measure and record all crown protrusions above the block parting surface at the area previously cleaned.If they are all uniform, the rods should be okay.If one measures short, that one is likely bent.
Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Rebadging '87 300e emr0591 Detailing and Interior 6 09-04-2007 10:12 AM
'86 300E vs '91 300E... Any opinions out there??? pjtib Tech Help 23 05-04-2005 10:26 PM
300E FIRST-gear start brewtoo Tech Help 16 03-11-2005 06:27 PM
Transmission Question 1988 300E (Need Technical help)n china beach Tech Help 4 03-26-2002 11:25 AM
300e Front suspension 210K( Inspection)? MikeV Tech Help 1 02-19-2002 02:54 PM



All times are GMT -4. The time now is 01:48 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2011 Pelican Parts - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page