how to get inside door,electric window, - PeachParts Mercedes-Benz Forum

MB300ENZ · #1 04-23-2004, 10:48 PM

How do I take away inside of door to reach electric window?

did drive on a bendy and hilly road, worst ever you can think and car made noises everywhere,,and then window stopped working on drivers side,
engine runs,,but it sounds as if the glaze has popped out of postion and I do not want top use or even try the button since it is noisy and I think I might damage,,how do I take away the inside of the dorr so I can have a look to see if there is something I can do myself ?

suzanne

joe p · #2 04-23-2004, 11:03 PM

Wow, you type worse than I do.

What year & model 300? Every generation is different.

Joe

MB300ENZ · #3 04-23-2004, 11:10 PM

300e 92

dunno how to attack the door

two screws inside dorrside at front of door,
or take away the pocket on the door and reach thru there ? and how take away pocket on door if so ?

MB300ENZ · #4 04-23-2004, 11:11 PM

I am not a typist to profession and I ain't english

joe p · #5 04-24-2004, 12:10 AM

Cool, I'm southern.

Aint I understand.

Ok, 124 door panel removal 101.

Remove lock button, screws off

If manual window, remove handle

Remove the little triangle inside the mirror, if manual mirror just let it hang by the handle.

Remove courtesy lamp in the bottem of the door panel, pops out, there is a small slot in it indicating the side the has the pressure clip.

Remove seat switch buttons and cover if you have power seats, if not, remove the trim cover.

Pop off the plastic cover surrounding the inner door handle and remove screw holing the top of the pull handle.

Bang the door panel upwards, its attached to the door with plastic L brackets made onto the door trim.

sounds long, takes 10 minites.

Reverse to install, its a bit tricky to get the front edge and rear edge aligned at the same time, do one end at a time and feel around the trim for gaps, if it has one you missed a L bracket.

Joe