|
|
|
|
|
#1
09-07-2000, 07:26 AM
|
|||
|
|||
|
When accelerating I have a pronounced hesitation between about 2500 to 3500rpm. Engine starts OK and idles fine, problem diminishes when car has warmed up.
I have changed the rotor arm and distributor cap, new plugs + air filter. Any ideas? The car has done approx 120k miles and runs fine otherwise. It uses about 1 litre of oil per 1000 miles and has a catalyst. Ben. (W126 300se 86 manual) 
|
|
#2
09-07-2000, 05:45 PM
|
|||
|
|||
|
Durning acceleration the air flow position sensor is responsible for fuel enrichment. The sensor sends increasing voltage signals back to computer & it SHOULD enrichen mixture. Also fuel delivery (quanity) is important (filter).
|
 |
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Hesitation again ('90 300SE) | fahrgewehr2 | Tech Help | 1 | 11-12-2003 04:40 PM |
| W126 91 300SE Loctite for cross member? | sixto | Tech Help | 3 | 07-11-2003 03:18 AM |
| 89 300SE hesitation | Boatguy789 | Tech Help | 4 | 11-05-2001 01:29 PM |
| W126 91 300SE ignition switch | sixto | Tech Help | 3 | 10-17-2001 07:29 PM |
| W126 91 300SE fog light switch | sixto | Tech Help | 2 | 10-02-2001 07:03 AM |
Linear Mode
