I AM TRYING TO REPLACE THE RIGHT AND LEFT REAR PARKING BRAKE CABLES, BUT AM EXPERIENCING PROBLEMS REMOVING THE CABLES. DOES ANYONE KNOW THE PROCEDURES ON REMOVING THESE CABLES? IS THERE A SEQUENCE ON HOW THE COMPONENTS SHOULD BE REMOVED?

DOES ANYONE KNOW WHERE I CAN GET A SCHEMATIC ON HOW THE COMPONENTS GO TOGETHER?

THERE ARE TWO PINS ON THE WHEEL HUB END OF THE CABLE. ONE HOLDS THE CABLE TO THE LEVER AND THE OTHER PIN HOLDS THE TWO PIECE LEVER TOGETHER. WHICH ONE GETS REMOVED AND WHAT IS THE BEST WAY TO REMOVE THEM? I NEED SPECIFICS.

You need to remove the cable ends from the actuator levers, then remove the cable housing retainer clips from the cable housing ends, then pull them out of the backing plates..

------------------
Jeff Lawrence
1987 300e
1989 300e
2000 Dodge Grand Caravan SE