|
|
|
#1
|
||||
|
||||
Lamda/EHA #'s Interpretation Help
Hey all, I'm a Newbie at this Lamda stuff so bear w/ me here:
These are the #'s I got today trying to figure out my warm hard start/low rpm prob on my 91 300TE and I need some help figuring out what exactly I am looking for and what needs to be done next. (fyi: I have recently replaced the EHA/O2 sensor/OVP and cleaned the ICV) EHA: Ign On + 4.2ma Eng On + 3.8ma Duty Cycle (via volt meter/arithmetic method): 70% Fuel Mix (Volts @ #3pin): 4.5v IVC- This one was funny. I could only get about 2ma out of it @ idle. Now from my (limited) understanding of this stuff I am running quite a bit lean, but what should I do about it? Just bump up the mix? Do I need a new Lamda Tower? (If so how do I get the other one off, or is it adjustable? It does have a steel ball on top.) What other piece of equiptment should I test/replace? I have read most everything I can find...but I'm still learning. Thanks a ton for any help, I'm really stuck w/ where to take this! -Matt-
__________________
Currently: 1972 350SL Euro 4spd 1973 BMW R75/5 1981 BMW R80GS 1995 FZJ80 with OM606 Conversion In Progress |
#2
|
||||
|
||||
Anybody? Do I just need to bump up the mixture? Or am I looking at a faulty part?
__________________
Currently: 1972 350SL Euro 4spd 1973 BMW R75/5 1981 BMW R80GS 1995 FZJ80 with OM606 Conversion In Progress |
#3
|
|||
|
|||
According to the chart on the CD, you should be seeing 20mA KOEO.
And I believe the 70% is the baseline ratio before the system goes into closed loop. If you are getting this with a hot engine, then the CD says you have no TNA (engine speed) signal.
__________________
Chuck Taylor Falls Church VA '66 200, '66 230SL, '96 SL500. Sold: '81 380SL, '86 300E, '72 250C, '95 C220, 3 '84 280SL's '90 420SEL, '72 280SE, '73 280C, '78 280SE, '70 280SL, '77 450SL, '85 380SL, '87 560SL, '85 380SL, '72 350SL, '96 S500 Coupe |
Bookmarks |
|
|