|
|
|
#1
|
|||
|
|||
93 300E 104.992(3.2) eng. 84,000mi.
I would like to find out how to retrieve the trouble codes using push button and LED light onthe diagnostic terminal. How do you properly erase all previous codes Using the push button and counting blinks of the LED light, I was able to extract the following codes: 32, 41, 44, 104, 105 What do the preceding codes signify? Items replaced since purchase in July: 0-2 sensor Plugs,bosch F8DC0 Plug wire,and long plug leads from ign. coils to the plugs. New engine electrical harness New water pump New thermostat New thermostatic fan clutch Engine seems to run fine,no miss or hesitation. Check engine light came on after a long drive. I disconnected the battery negative cable with the ignition switch in the on position, and the check engine light went out. |
#2
|
|||
|
|||
I only have codes for my car (300CE). I am shure someone will be able to provide the table with codes for yours. In order to reset the light you need to corect the problem, than turn the ignition to the "on" position press the buton next to the led indicator for at least 6 sec. The led will blink once indicating that the foult code has been cleared. If you have more than one foult codes, than read off the codes one by one (press buton for 2-3 sec and wait for it to blink) doing the clearing procedure described above after each code had been read.
Dmitry 90' 300CE [This message has been edited by DMITRY (edited 10-02-2000).] |
#3
|
|||
|
|||
When the check engine comes on my 140 with the 104 engine at 65K miles, I found the problem was the engine wire harness insulation were broken, cause the wires to tough each other at the thermostat housing. After I separated the wires, reset by disconnect the battery. The check engine goes away.
MB replaced the wire harness under warranty, I paid for labor. jack |
#4
|
|||
|
|||
I would try blinking those codes again, none of the codes that you listed have any meaning.
|
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
FS 300e w124 PARTS ON EBAY!!!!!!! | 6cndmbz | Mercedes-Benz Used Parts For Sale & Wanted | 4 | 09-20-2003 12:14 PM |
Trouble Codes Question | talons40 | Tech Help | 2 | 08-22-2003 02:36 PM |
Help with retrieved trouble codes | pmizell | Tech Help | 1 | 03-27-2003 11:25 PM |
ODBII Trouble Codes reset in 1995 W140 | ehmand | Tech Help | 5 | 03-04-2003 11:34 PM |
E320 (w124?) trouble codes | BAVBMW | Tech Help | 1 | 12-30-2002 06:50 PM |