|
|
|
#1
|
|||
|
|||
Injector holder question
I know this is a dumb question but I can't figure it out.
I've bought new fuel injector seals and holders for my 76 450sl, and right below the O-ring the holders have little tabs - that aren't on the holders that come out of the car. (picture enclosed) But the tabs seem to keep the O-ring from seating properly - or perhaps I've bent them a bit. Are the tabs necessary? Do they bend over the O-ring or just slide down into the opening in the engine? Thanks |
#2
|
|||
|
|||
The whole thing just slides in.
Lee |
#3
|
|||
|
|||
thanks lee.
that makes sense but I wanted to be sure. |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
W116 spacers/ offset question | MrNemo | Mercedes-Benz Wheels & Tires | 6 | 08-03-2008 04:39 AM |
83 300CD tranny modulator question | freesprung | Tech Help | 0 | 04-07-2004 10:10 PM |
Trouble Codes Question | talons40 | Tech Help | 2 | 08-22-2003 02:36 PM |
Center Console Question | hippie_elmo | Vintage Mercedes Forum | 2 | 02-01-2002 11:47 PM |
190E tire question | cossie | Mercedes-Benz Wheels & Tires | 14 | 01-31-2002 05:49 PM |