|
|
|
#1
|
|||
|
|||
111 Finny wiring HELP
Can anyone tell me the colors and positions of wires on the back of the alternator for my W111 Finny 230S with M180 ???
|
#2
|
|||
|
|||
Is this any good to you? from a UK 1963 220 se
|
#3
|
||||
|
||||
That's a generator.
__________________
Regards Warren Currently 1965 220Sb, 2002 FORD Crown Vic Police Interceptor Had 1965 220SEb, 1967 230S, 280SE 4.5, 300SE (W126), 420SEL ENTER > = (HP RPN) Not part of the in-crowd since 1952. |
#4
|
|||
|
|||
Thanks a ton, but mine is WAY different to that.
I think it is an alternator, but it DOES seem to have a 'voltage regulator' (?) with 3 wires attached to the right side of the radiator support. my alternator (?) has 4 posts on the BACK FACE (towards the firewall) VERY near to the exhaust...I will splice in some fresh wire, routed AWAY from the exhaust as much as possible, with a nice, neat 4 pin connector. ANY guidance at ALL will be extremely helpful (eg....B+ - red / B- - black w white trace etc etc) |
#5
|
|||
|
|||
Does it look like this? If so,it has an external regulator(what you see on the right rad .support) .However,the connector is 3-pin(on newer models the pins are not round,but flat)...the 3 cables are color coded,will give you the info tomorrow.The 4-th cable is ground,connected to the small 8-mm nut on the generator corpse. Check out this thread,pics of alt.: Internal or external voltage regulator...I'm confused. Where to get brushes? |
#6
|
|||
|
|||
OK....here's what I've got!
FOUR pins: B+ D+ D- DF ....and FOUR wires FAT Red (currently connected to B+) thin Black thin Brown thin Red w blue trace NOW......what goes to what?????? |
#7
|
|||
|
|||
pINS AND WIRES
DF=Black
D-=Brown DT=red with blue line BT=THICK RED WITH O RING TO SLIDE ON POST |
#8
|
|||
|
|||
Thanks a BUNCH !!!!!!!!
|
#9
|
|||
|
|||
Welcome
U R welcome. Hope it goes well.
|
Bookmarks |
|
|