|
|
|
#1
|
||||
|
||||
W108 ingition switch removal
Need some help on removing the entire assembly from the steering column. Long story, but I was attempting to pull the electrical connector from the switch today and instead I pulled the rear part out of the switch.See below.
I need to remove the entire switch so I can make sure to reassemble properly. I've loosened the clamp at the bottom of the switch where it attaches to the steering column but I don't detect any movement away from the column, it just rotates a bit. Am I being to gentle or is there some step I'm missing. Thanks
__________________
Joe ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ 1980 300SD - 495k miles - 'The Ambassador' ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ Former Family Members 95 C280 73 280SEL 90 300D 87 300SDL (X2) 86 560SEL 84 300D 80 300SD |
#2
|
|||
|
|||
I ve tried one myself - there seems to be a slot just beyond that 10mm bolt nut ?
The slot needs to be depressed and a key inserted - both at the same time ? Perhaps someone here can chime in with more details . Mine ultimately came out but it was tedious |
Bookmarks |
|
|