Seat belt recommendations

[II Kings 9:20]

I have a 1980 300SD and all 4 sea tbelts are frozen. I was able to spool in the driver's unit and pull it out so I can wear it but it is finnicky.

Any recommendations on replacing. I have a couple of sources for used belts that are said to work properly and in good condition.

I would like to get new belts but at $350 each for a car that is going to be driven to auto shows and on rare occasions is too steep.

I searched here and found a good solution to try for the fronts and will try but the rears have a fair amount of rust on the male end.

[Pooka]

As many 123's as are out there then you would be better off just placing an add in the 'parts for sale/wanted' section of this board. These are easy to replace and as cheap as used belts are there is no sense in trying to revive belts that have rusted up.

Shoot a picture of your belt ends and say 'Need these'.

[II Kings 9:20]

Originally Posted by Pooka

As many 123's as are out there then you would be better off just placing an add in the 'parts for sale/wanted' section of this board. These are easy to replace and as cheap as used belts are there is no sense in trying to revive belts that have rusted up.

Shoot a picture of your belt ends and say 'Need these'.

You are right, they could not be revived and not worth the risk.

I'll post what I need. Thanks.