|
|
|
#16
|
|||
|
|||
Tom, Graham,
The fan is not yet installed, so I'm sure that's not it :-) The v-belts are not on either. I had the pistons/rods out and I did not see any visible damage. I suppose there is a chance I did not tighten one of the rod cap bolts, but I am usually very thorough with that kind of stuff. I have cranked it for probably 2 minutes (a total of many times), so I would think the tensioner got enough oil. I will crank it more when a friend comes over to look at it, so if it's just that then it should go away soon. I did check the cam timing on the right side and it lined up, plus the lobes on #1 were pointing up, which makes sense when the piston is at TDC. Thanks, Csaba |
#17
|
|||
|
|||
It runs!!
Got the engine started! Apparently the noise comes from the starter or ring gear, as it only happens while cranking.
There are new issues, I will post them in a new thread including a video of the startup. Csaba 72 280SEL 4.5 |
Bookmarks |
|
|