|
|
|
#1
|
|||
|
|||
230SL, 250SL, 280SL jump time? Chain stretch?
Has anyone with a Pagoda every have their car jump time due to a loose chain? My 280SL has what I believe to be an original chain which seems to be OK now (125K miles), but after all these years, I'm concerned about stretch picking up quickly...are most people putting in new chains as a precaution?
|
#2
|
|||
|
|||
I change them out at about 100,000 miles.
|
#3
|
||||
|
||||
I wouldn't expect the chain to be a problem on the M130 - even though I have never worked on one - the diesel engines of that period had more chain elongation / stretch problems so much so Mercedes made off set keys to adjust the camshaft timing.
The process of measuring the elongation is commonly termed as the "2mm lift test". This in similar forms is used to assess the condition of the chain for many other engine types. I imagine it is also explained in the M130's workshop manual.
__________________
1992 W201 190E 1.8 171,000 km - Daily driver 1981 W123 300D ~ 100,000 miles / 160,000 km - project car stripped to the bone 1965 Land Rover Series 2a Station Wagon CIS recovery therapy! 1961 Volvo PV544 Bare metal rat rod-ish thing I'm here to chat about cars and to help others - I'm not here "to always be right" like an internet warrior Don't leave that there - I'll take it to bits! |
#4
|
|||
|
|||
The chain in a diesel is different than in a gasoline power engine. They both wear and at about the same rate.
I've replaced a lot of them on both engine types. |
#5
|
||||
|
||||
when it doubt, measure the stretch. Set the crank to TDC by hand and look at the cam timing mark.
If you're really clever, figure out which comes first the TDC mark or the cam tower mark and then figure out how much along the crank you need to go to get the other one lined up. If there's enough stretch to do something about, you can correct the timing with an offset key under the gear or you can turn a whole new chain into place. -CTH |
Bookmarks |
|
|