|
|
|
#1
|
|||
|
|||
Difference between m180.945 and .947?
I’m getting ready to pull the head because half of the valve keepers just won’t come out no matter how much i hammer on them. I have the m180.945. I can’t find the head gasket anywhere for this engine but there’s one for the 230s and after checking it’s the .947 engine. Will this fit? If not is there anywhere else I can look before I call up the classic center?
https://www.pelicanparts.com/More_Info/1800164620.htm?pn=180-016-46-20-INT&gclid=Cj0KCQiA04XxBRD5ARIsAGFygj9OCYhbMNjs5PRrHJpDix5wwqCfzat0G0qZ71hgMSFTkxaA_8V0fVUaAriCEALw_wcB |
#2
|
|||
|
|||
epc shows the following part number for a head gasket for M180.945 :1800164620
so the one in your link should work but make sure to double check the part numbers before buying |
#3
|
|||
|
|||
I don't know about the gasket. Have you tried putting air in the cylinder, putting a socket over the tip of the valve onto the spring and striking the socket?
Good luck!!!
__________________
"Rudeness is a weak man's imitation of strength" - Eric Hoffer |
Bookmarks |
|
|