|
|
|
#1
|
|||
|
|||
Solex 4A1 vacuum governor question
Folks: While re-adjusting the idle(which was too high) I tested the vacuum governor with a pump and gauge and find it has a slow leak.
I have had no luck sourcing this on-line. Can anyone point me to a source. The car is a 74 280C with the newer TN Solex 4A1 carb. Thanks. dougq Last edited by dquance; 10-05-2007 at 09:24 PM. Reason: spelling mistake |
#2
|
|||
|
|||
The vacuum governor...
raises the idle when the accelerator is quickly released.
I plugged the line and have been running without it for 3 years.
__________________
1970 280S M130 engine- good runner 1971 250 M130 engine- #2 rod bearing, gone 1971 280SE (blown engine,parts car) 1977 German 280S W116-only 33 years old |
#3
|
|||
|
|||
Have you tried a MB dealer? This is shown as a replacement part in Group 7-1. You might have to ask them for a european search. There is also a web site, rudddies-berlin, that carries parts for the 4A1. This was a widely used carb, so this piece should not be hard to find.
__________________
Chuck Taylor Falls Church VA '66 200, '66 230SL, '96 SL500. Sold: '81 380SL, '86 300E, '72 250C, '95 C220, 3 '84 280SL's '90 420SEL, '72 280SE, '73 280C, '78 280SE, '70 280SL, '77 450SL, '85 380SL, '87 560SL, '85 380SL, '72 350SL, '96 S500 Coupe |
Bookmarks |
|
|