|
|
|
#1
|
||||
|
||||
W108 Window regulator installation help
I got a new LF window regulator but I can't find the way to install to the window metal channel.
Anybody has a picture of the window metal part where the regulator attaches? Mine looks like a J, maybe it's bent? It's impossible to pass the pin tru it! I looked on the RF and its straight, so the regulator, then the white plastic and then the clip can go straight. |
#2
|
||||
|
||||
__________________
1972 W108 280SE 4.5 1977 W116 450SEL 1981 E12 528i BMW |
#3
|
||||
|
||||
Is this how the LF window bracket supposed to look?
If so mine is bent badly. Last edited by Adv_rider; 01-20-2013 at 01:18 AM. |
#4
|
||||
|
||||
Nobody?
|
#5
|
||||
|
||||
Your 2nd pic is right. Looks like, in the first pic, the arm came out of its channel and rode along the bottom of the window, bending the piece at a 90° angle as it raised the window from below the channel it needs to be in.
__________________
Current: 2021 Charger Scat Pack Widebody "Sinabee" 2018 Durango R/T Previous: 1972 280SE 4.5 2014 Jeep Grand Cherokee Limited "Hefe", 1992 Jeep Cherokee Laredo "Jeepy", 2006 Charger R/T "Hemi" 1999 Chrysler 300M - RIP @ 221k |
#6
|
||||
|
||||
Quote:
The metal on the bracket appeared too strong to be bent, so I couldn't figure out why the design was like that. |
Bookmarks |
|
|