|
|
|
#1
|
|||
|
|||
w113 bellhousing
Does anyone out there know if a 1112502105 bell housing used on a w113 is the same bolt arrangement as the newer om616 engine? It appears to be pretty close. Does anyone have a drawing or bell housing laying around that could be measured?
|
#2
|
||||
|
||||
You asking for dimensions from the 113 or 616? Do you know about the forum for pagoda roof cars?
__________________
[SIGPIC] Diesel loving autocrossing grandpa Architect. 08 Dodge 3/4 ton with Cummins & six speed; I have had about 35 benzes. I have a 39 Studebaker Coupe Express pickup in which I have had installed a 617 turbo and a five speed manual.[SIGPIC] ..I also have a 427 Cobra replica with an aluminum chassis. |
#3
|
|||
|
|||
the w113
the w113 bell housing, is it similar to the om616 other than provision for bolt arrangement on trans side?
|
#4
|
||||
|
||||
As far as the engine side is concerned, the bells are interchangable. However, you'll find lots of changes over the years regarding throw-out bearings, slave cylinders and such. You probably need to keep the bell with the trans and clutch. -CTH
|
Bookmarks |
|
|