|
|
|
#1
|
|||
|
|||
Heater control parts
1971 280se 108018 Hey, guys, I'm in trouble. I just replaced all 4 of my heater control levers, pluged in the light connector,CRACK!!!! Round center section broke (it was suspect but thought it would make, NOT) I need the complete black round center section, top and bottom. I would buy a complete unit, don't care about the levers as mine are new. I actually only need the right hand cylinder as the left one is ok. can anyone help me out or direct me to a source?
Thanks Jerry
__________________
Jerry - If you don't learn something new every day, you aren't paying attention!! 1971 108 280SE 2.8 "Ronnie" 1985 300TDT (76,904 Original miles ) "Sadie" (Sold-went back to Arkansas) 1984 300DT "Green-go" (Sold) 1984 300DT "Silver Bullet" (Sold) 1956 220S Ponton 1985 300D (Sold) 1984 300D |
#2
|
|||
|
|||
Heater Control Parts
Update, after removing the control assembly, the only part I really need is the lower half of the right hand side black cylinder (the lower half of the cylinder where the light connector attaches). If anyone has a junker control with this part good, I'll gladly pay for it.
Thanks Jerry
__________________
Jerry - If you don't learn something new every day, you aren't paying attention!! 1971 108 280SE 2.8 "Ronnie" 1985 300TDT (76,904 Original miles ) "Sadie" (Sold-went back to Arkansas) 1984 300DT "Green-go" (Sold) 1984 300DT "Silver Bullet" (Sold) 1956 220S Ponton 1985 300D (Sold) 1984 300D |
#3
|
|||
|
|||
Heater control parts
Never mind, found repairable unit.
Thanks Jerry
__________________
Jerry - If you don't learn something new every day, you aren't paying attention!! 1971 108 280SE 2.8 "Ronnie" 1985 300TDT (76,904 Original miles ) "Sadie" (Sold-went back to Arkansas) 1984 300DT "Green-go" (Sold) 1984 300DT "Silver Bullet" (Sold) 1956 220S Ponton 1985 300D (Sold) 1984 300D |
Bookmarks |
|
|