|
|
|
#1
|
|||
|
|||
1967 230S clutch master cylinder
I am in the process of replacing my master and slave clutch cylinders on my 230S. I ordered the FTE part number 0002952406 which is the replacement part listed. However, the hydraulic port that runs to the slave is larger than my old master cylinder. It measures M14x1.0 which I cannot find - not even a local hydraulic shop can find fittings that size. Has anyone run across this? I had a mechanical engineer coworker confirm the measurement.
Thanks in advance for any insight. |
#2
|
|||
|
|||
Hey BenzInBoulder....give us a call at 888-280-7799 and our Parts Specialist will help you find and make sure that the part will be compatible with your 230S.
-Dmitry |
#3
|
|||
|
|||
Thanks for the response.
I ended up honing my old master cylinder and swapping the internals from the new master to the old master. That proved quicker and easier than locating a M14x1.0 flare nut. Thanks again. |
#4
|
|||
|
|||
No problem. Glad you were able to fix it.
|
Bookmarks |
Thread Tools | |
Display Modes | |
|
|