PeachParts Mercedes ShopForum

PeachParts Mercedes ShopForum (http://www.peachparts.com/shopforum/)
-   Vintage Mercedes (http://www.peachparts.com/shopforum/vintage-mercedes/)
-   -   Fan clutch springy thing? (http://www.peachparts.com/shopforum/vintage-mercedes/385113-fan-clutch-springy-thing.html)

300decel 04-02-2017 09:54 PM

Fan clutch springy thing?
 
My water pump replacement went OK, thought I had all bits ordered. This afternoon I did a Diesel Purge* and while the return fluid was clear, the idle sounds better to me.
When I shut the car off I heard a "ping" on the concrete garage floor and found the flat piece in the pic.
Is it vital to the fans operation? If I recall it was on the front of the fan clutch.
I would not like to pull the radiator to try and reinstall it unless it's really necessary.
http://i1134.photobucket.com/albums/...g?t=1491094001:confused:

compress ignite 04-02-2017 11:19 PM

All you EVER need to know about Viscous Fan Clutches on Mercedes
 
(Other than REPLACING the Damn Viscous Fan Clutch setup with an Electric
"Puller" Fan setup is the Long Term solution.)

Anyway, read and View Jim's Tutorial
(Man, He sure knows his S**t)



http://www.peachparts.com/shopforum/diesel-discussion/195595-refill-viscous-fan-clutch-pictures.html

BUT ! If y'all KEEP the Viscous Fan Clutch you'd BEST be replacing that Spring !

97 SL320 04-04-2017 08:29 PM

Be glad it didn't hit a fan blade and go through the radiator , sever coolant hoses , get caught in a belt or go through the hood.

Unless this spring is available as a service part ( I doubt it is ) replace the fan clutch.

300decel 04-04-2017 11:16 PM

Nope, I've done all of the fussing with this pain in the butt fan I care to do. :)

Decided to go with an electric fan instead. With the mild weather here in the Pacific Northwest I'm not terribly concerned about overheating, and a good electric should fit the bill nicely.

I understand not everyone agrees on junking the clutch setup, but I like the idea.
:vbac47679

280EZRider 04-05-2017 03:03 PM

Since you are going to replace the original fan with an electric, this is a moot point, however, itīs not necessary to remove the radiator to remove the fan (maybe so to install an electric assembly).

The metal strip you found, which pops back and forth from temperature change - which looks severely bent and thus its falling out - is a thermostat. When the engine is cold the fan runs constantly. After the engine along with the metal strip gets warm, the metal strip bends slightly and pushes on the pin behind it, which allows the oil in the chamber to flow, allowing it to now control the function the fan by RPM.

Unfortunately, I donīt think you are going to find an electric fan with the longevity that a mechanical fan has. If this were the case, you could wire the aux fan to run at specific temperatures.


All times are GMT -4. The time now is 02:16 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2011 Pelican Parts - Posts may be archived for display on the Peach Parts or Pelican Parts Website