|
|
|
|
|
#1
05-03-2017, 10:00 PM
|
||||
|
||||
|
BBS RS 010 Fittment on W123
Hello,
I've no experience figuring out what wheels will fit with out actually mounting them. There are a set of BBS RS wheels for sale about an hour drive from me. They're stamped 7J x 15 H2 ET38. Anyone running offset that high on a w123? From all the posts I've browsed looks like these wont fit. I'd be willing to run a 10mm spacer but would think I shouldn't run much more than that. Anyone have some experience with something like this?
__________________
-------------------------------------------- Old Blue - 83 240D 6 speed manual trans, OM648 Green Machine - 2001 Europa G500 87 300SDL Bought on Peachparts. Low-ish miles..? Family Truckster - 2012 VW Touareg TDI Patchouli Wagon - 2004 E500 - SOLD 333k mile 97 BMW 750il V12. - SOLD The Californian - 85 300TD - SOLD Daily Super Sedan - 03 Audi S8 -SOLD 
|
|
#2
05-04-2017, 05:21 PM
|
|||
|
|||
|
Take a look at the link below - it's a great guide that will help you figure out the fitment and spacing.
Wheel Fitment & Spacing Guide
|
|
#3
05-22-2017, 04:01 PM
|
||||
|
||||
|
I have a set of BBS 16x8 et11 on my 123. Perfect fit in rear. On the front, a slight poke. But I like it.
Sometimes folks run a staggered et11 and et23 to prevent that slight poke. Now I've also ran a set of 15x6.5 et37 8 hole Mercedes wheels with cheap 10mm spacers. Not too bad, but I do think it was pretty wide and should be run with hubcentric type spacers. Definitely needed longer bolts. I would imagine with the wider rim, 7 vs 6.5, and the et38, you'll need a wider than 10mm spacer to clear the front tie rod. .
__________________
1983 123.133 California - GreaseCar Veg System 
|
 |
| Bookmarks |
|
|
Linear Mode
