if you notice my jack stand under the arm its not even raised 1 notch and the spring is compressed quite a lot too.

So unless the metal square structure of the jackstand lets go Im pretty good.

This press is definitely lots better than the one screw C shaped one as you can really crank these nuts without fear and hit it HARD with a hammer too.

the cost in ordering was about more than a 100 USD, why not just make it, Im sure you can source a place that has some scrap steel plates and also find a place that can drill out holes for you.

__________________
2012 BMW X5 (Beef + Granite suspension model)

1995 E300D - The original humming machine (consumed by Flood 2017)
2000 E320 - The evolution (consumed by flood 2017)