|
|
|
#1
|
||||
|
||||
W126 stereo install problems
Good morning everyone. I'm somewhat of a novice at this so I have some questions. I'm installing a new stereo in an 86 500SE euro and I seem to have run into a snag. I bought the car without a radio and it looks like some of the wiring has been messed with but I can't tell for sure, the fader switch was unhooked and wrapped with elec. tape and it had 2 small pins stuck inside that were jumping some of the connectors, I don't know what effect this was having but I removed the pins. Here are the wires I've been able to sort.
In the four pin connector: brown-ground black-12vconstant (I think, I'm at work and all this is written down at home) red/white-12vswitched 2gray/purple-dimmer (won't be using, I guess I just tape this off to keep it from grounding correct?) there are four pairs of wires I thought were each one speaker but it turns out after reading in here I'm wrong. red/black green/black white/black <-still had the factory connector attached yellow/black <-still had the factory connector attached I was testing with a 9v to see which wires were for which speaker and I can't get the back ones to pop, which wires do I need to cut at the fader and extend to the front to the head unit. I really really do not want to run new wires for the rear I just want to bypass the fader switch. Remember I have a basic understanding so please be descriptive! thanks!!
__________________
E30 B25 126.036 123.130 with 616-Frankenbenz (sold) 124.030-Greyhound (sold) 124.030-Schnauzer (sold) DERP DERP |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|