|
|
|
#1
|
||||
|
||||
Vacuum control valve
I have seen so mention of adjusting the vacuum control valve. I can find the valve but how and where do I adjust it? There is a plastic part on the side that looks like it might be a cover for something. Is this a cap that I need to remove to access an adjustment screw? Help. I have found all or most of the vacuum leaks, I HOPE, and now want to start fine tunning the system.
__________________
1983 300SD 200000miles |
#2
|
||||
|
||||
Are we allowed to post links to the other Mercedes list site??? Any this is the article I always refer to. I'm new to this list but I have been active on the other list site for many years. (no annoying avators or smile thingys)
http://transmission.articles.mbz.org/adjust/
__________________
Bill Reimels Now down to one: 1972 300SE 3.5 W109 (Euro delivery) |
#3
|
||||
|
||||
Yes there should be a removable cap, looks like a plastic dome. Under it you may find it is either unadjustable or has a little slot on it for a small wrench so that it can be adjusted. The number should be as close to 0" as possible at WOT and should be at least 13" at idle, any lower will cause a clunk going into gear. 15" at idle would be prefered. There are several other tranny adjustment links on the page linked in my sig.
__________________
Jeff M. Mercedes W123 DIY pages are now located here. 1983 / 1984 300D Sold 2000 CLK430 Cabriolet ~58k Sold 2005 Avalanche 4x4 ~66k |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
450SL Cruise Control | 450sl4me | Mercedes-Benz SL Discussion Forum | 4 | 04-16-2005 01:01 AM |
engine stop and climate control vacuum?? | moruzzi | Diesel Discussion | 2 | 01-16-2005 09:55 PM |
broken vacuum valve w123 | twinturbo | Diesel Discussion | 1 | 01-02-2005 08:27 PM |
Valve cover gasket replacement – 95 E320. | 71Rcode | Tech Help | 0 | 03-10-2004 08:44 PM |
Idle control valve broken?? W126 | finn | Tech Help | 7 | 08-10-2003 03:40 PM |