|
|
|
|
|
#1
03-25-2005, 12:50 PM
|
|||
|
|||
|
starting problems
I have an 83 3oosd.
Never had hard starting, now the glow light does not come on and it takes two time to start cold with a lot of smoke. I changed out the glow plugs approx 2 years ago. The relay shuts off after approx 30 seconds with no starting and the fuse is good. Any thoughts??/
__________________
83 300SD, 136k. 
|
|
#2
03-25-2005, 01:26 PM
|
|||
|
|||
|
How is the GP wiring?
Unplug the 5-wire plug from the top of the relay. Check resistance between the contacts on the plug to ground. You should measure about 1-2 ohm.
You did not indicate how you know the relay is working, (audibly or with a voltmeter?). I you have not done so yet, check that you have 12V output at the relay when it is on.
__________________
1985 300SD, 203,000 miles, dark blue Lil Sarah says: "Poor old Grandma Blue Car...She's sad."
|
 |
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 87 190E 2.6 hard starting problems. | Ralph Todd | Tech Help | 11 | 11-07-2008 09:25 PM |
| Occasional starting problems | Nightstalker | Tech Help | 1 | 02-13-2005 04:08 PM |
| 420 SEL Starting Problems + Low idle etc | xsohaib | Tech Help | 6 | 05-08-2003 04:38 PM |
| 126 hot starting problems | Robbo | Tech Help | 0 | 12-20-2002 12:14 PM |
| 260E starting problems | fiver64 | Tech Help | 5 | 10-19-2000 09:15 PM |
Linear Mode
