|
|
|
#1
|
||||
|
||||
euro headlight leveling installation insight requested
I am going to be installing euros in my SDL this Sunday but I will be putting the headlight facia and adjusting wheel in tomorrow. Basically, all I need to know is how much of the hard line to buy? So far on my shopping list for this includes:
1 vac. check valve 2 "Y" splitters (1 to connect the two headlights to one line then the other to connect to a vacuum source) ?" of hard vacuum line. Do you ladies and gentlement know of anything else I'll need to buy? How about tips for removing the facia surrounding the headlight switch. I have a new used one and I don't really see an easy way to remove those spring clip things that hold it in. So far I plan to pull the cluster and undo the big 24mm nut once the nob is pulled off. Then, once the cluster's out I think I have to remove the center vents which will then give me access to the nuts holding the dash wood on, correct? When I pull the dash wood piece off will it pull the facia with it? Thanks David
__________________
_____________________________________________ 2000 Honda Accord V6 137k miles 1972 300SEL 4.5 98k miles _____________________________________________ |
#2
|
||||
|
||||
Maybe this will help, its not written very well, but you should be able to gain something from it.
http://www.geocities.com/audi_tech_rs4/W201_Headlights.html and yes, most of the parts were "stolen" from my wagon found this as well: http://www.w123-world.org/attachment.php?attachmentid=237
__________________
1980 500SE/AMG Euro 1981 500SEL Euro 1982 380SEL 1983 300TD 1983 500SEC/AMG Euro 1984 500SEC 1984 300TD Euro 1986 190E 2.3-16 1986 190E 2.3 1987 300D 1997 C36 AMG 2003 C320T 4matic past: 1969 280SE 4.5 | 1978 240D | 1978 300D | 1981 300SD | 1981 300SD | 1982 300CD | 1983 300CD | 1983 300SD | 1983 380SEC | 1984 300D | 1984 300D | 1984 300TD | 1984 500SEL | 1984 300SD | 1985 300D | 1986 300E | 1986 560SEL | 1986 560SEL/Carat | 1987 560SEC | 1991 300D 2.5 | 2006 R350 |
#3
|
||||
|
||||
On my '84 300D, the headlight aiming cntrol is in the centre switch panel.
__________________
Tony from West Oz. Fatmobile 3 84 300D 295kkm Silver grey/Blue int. 2 tank WVO - Recipient of TurboDesel engine. Josephine '82 300D 390kkm White/Palamino int. Elizabeth '81 280E, sporting a '79 300D engine. Lucille '87 W124 300D non-turbo 6 cylinder OM603, Pearl Grey with light grey interior Various parts cars including 280E, 230C & 300D in various states of disassembly. |
#4
|
|||
|
|||
vacuum line
i would say 8-10 feet, mercedes sells the line by the meter, so figure that to feet, also here are a few illustrations that may help
Last edited by carson356; 02-05-2006 at 02:35 PM. |
#5
|
||||
|
||||
Thank you very much gentlemen. I think I might just go back to the junkyard with the euro 500SEL and pull the lines, connectors, etc.
Also, what would I need to pull from this euro 500SEL to give my car the rear fog light? If I would have to install a whole new wire or harness forget about it though it would be nice. Thanks David
__________________
_____________________________________________ 2000 Honda Accord V6 137k miles 1972 300SEL 4.5 98k miles _____________________________________________ |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
W126 420SEL euro head light installation. | afmcorp | Tech Help | 11 | 03-02-2005 11:57 AM |
FS: w124 Euro Headlight Vacuum adjust kits | omegabenz | Mercedes-Benz Used Parts For Sale & Wanted | 1 | 07-07-2004 10:13 PM |
W123 Euro Headlight Grounding Problems | BoostnBenz | Tech Help | 4 | 05-31-2003 04:04 PM |
Euro Light/Wiper Conversion | barrie | Tech Help | 0 | 01-11-2003 04:26 PM |
Euro Headlight Wiper Blade Part Number | steif1 | Diesel Discussion | 0 | 05-23-2002 08:50 PM |