After searching the website I have not been able to find where any one else has had the same symptoms that I am having with my 300. But similar.

I have a 79 300SD that is blowing very hot air through the A/C vents on the right and left but air does not blow through the center vents. Also hot air blows through the heater vents on the floor. When the A/C is not on hot air still comes through the vents. The faster you drive the hotter it is and when the A/C is on it blows fairly cool at an idle. When you stop the A/C is able to cool the car down again. I live in the Dallas Texas area it has been 100 degrees lately and it is unbearable to drive my car at this time.

The compressor has been replaced with a new one (Not a reman.), receiver/drier, low pressure hoses and recharged with a low pressue of 30 and the high pressure is 300. The monovalve was leaking coolant and I replaced it with one from the salvage yard from 1980 model that fortunately is made of metal instead of plastic. After reading through portions of the forum I took a pair of needle nose vise-grips and effectively shut off the heater hose on the drivers side of the cylinder head and there did not seam to be any change.

The car has been sitting in my grandfathers hay barn for the last 6 years with 135,000 miles. The only thing he was aware of is that it had a leak that I fixed with new hoses.

Your help is appreciated.

Tony

Check all the vacuum lines for leaks. It is obvious that you are getting outside hot air blown in through an open recirculation door, but if the air is too hot to stand then you might be still getting hot coolant through that neddle nose. I found that the best way to avoid the problem with the monovalve is to just bypass it all together with a hose from the left side of the head to the pipe that the monovalve drains to on the other side of the eng. I did this on my 84 300sd (sold)

__________________
87 300d Turbo 241K with original #14 head (blue)
87 300d Turbo 198K will run great again someday (silver)
84 300sd sold ( buyer drove it to Paraguay )

You'll need to locate the big ugly servo unit on the passenger(?) side of the engine, youre going to have to clamp off one of the hoses from it- I'm recalling from memory as none of the cars I've owned has had one, and I've rarely touched 116 body SD's. I've helped a few of my friends with them in the past, but only on 123's and 107's etc....

keep us posted if that works...

__________________


1980 500SE/AMG Euro
1981 500SEL Euro
1982 380SEL
1983 300TD
1983 500SEC/AMG Euro
1984 500SEC
1984 300TD Euro
1986 190E 2.3-16
1986 190E 2.3
1987 300D
1997 C36 AMG
2003 C320T 4matic

past: 1969 280SE 4.5 | 1978 240D | 1978 300D | 1981 300SD | 1981 300SD | 1982 300CD | 1983 300CD | 1983 300SD | 1983 380SEC | 1984 300D | 1984 300D | 1984 300TD | 1984 500SEL | 1984 300SD | 1985 300D | 1986 300E | 1986 560SEL | 1986 560SEL/Carat | 1987 560SEC | 1991 300D 2.5 | 2006 R350

The center vents only blow ambiant temp air when the dial is set at the right point....nothing comes out at other times.....

the '79 300SD does not have a monovalve...it has the evil vacuum servo designed by some guy in Chrysler that spent the remainder of his life in a straightjacket in a padded cell in the 60's. I suspect LSD had a part in its design but I can't prove that.

These will die and would say few from the bone yards will actually work......unless you saw it work on the car it came off of.

There is a related servo amp behind the glove box. One can fry the other....recomend replaceing both at the same time.

__________________
Proud owner of ....
1971 280SE W108
1979 300SD W116
1983 300D W123
1975 Ironhead Sportster chopper
1987 GMC 3/4 ton 4X4 Diesel
1989 Honda Civic (Heavily modified)
---------------------
Section 609 MVAC Certified
---------------------
"He who fights with monsters might take care lest he thereby become a monster. And if you gaze for long into an abyss, the abyss gazes also into you." - Friedrich Nietzsche

Thank you for the replies.

Just to clarify, it seems like the heat is coming from the heater core. Very hot. Or it is coming from the engine compartment.

What setting on the dial will cause the A/C to blow through the center vents? I have it maxed out now. Is the servo the square looking thing with black plastic on top with vacum lines going into it on the passengerside of the firewall? Can you be more specific about the location of the, "servo amps", behind the glovebox? What do they look like? Are the amps a dealer only item?

Is it possible that the fresh air door is broken?

Thank you

Tony

Also, I did not see the servo work before buying it at the salvage yard. Are there rebuild kits for the servo?

Thank you

Tony

GREAT POST!!!!!!!!!!!!

I hope there are some who noticed that by indicating the model and year, a good post title and a good description of the problem, that Tony has gotten lots of good replies!

Thank you,