|
|
|
#1
|
||||
|
||||
Anyone removed Bumper Ends on a US Spec 123
I'm getting ready to put Rag Doll into the paint shop, but I wanted to replace the bumper ends. DOes anyone know whats involved in removing the front and rear bumper ends?
TIA DUb
__________________
91 350SD 14 F150 Eco 19 Fusion Hybrid 11 GT500 |
#2
|
||||
|
||||
If you are talking about the rubber ends the rears have some screws holding them from inside the trunk the frts have some thru the fenders plus what holds them to the bumper not that tough if you just look at how it is held on have you looked?
__________________
89 Ford F3504x4CC 7.3 IDI turboed Intercooler and running on wvo now powered by a 1997 Cumins 87 300SDL on bio and wvo killed by chevy truck 5-24-06 1999 E300TD black with gray int. |
#3
|
|||
|
|||
Yes, also thle front nuts in the fender are usually covered with undercoating & crud. A good time also to check the metal frames in the ends. Mine were all but gone from rust. They are readily available. Another 123 under resto - nice! Paul.
__________________
1984 300CD red/blk 290,000 partial resto 1980 240D 4 sp Brn/palomino gone 1997 Mazda Miata STO edition wife's baby 1988 Lincoln Mark VII LSC next resto 1986 Subaru GL wagon daily 1993 Isuzu pickup field beater 2008 Honda Civic EX-L 5sp wife's new car 1978 Honda XL350 1974 Honda XL70 my Calif. ride in HS |
#4
|
||||
|
||||
They just come off with a few fasteners. Look up under them and you will see.
__________________
1981 300D 147k 1998 VW Jetta Tdi 320k 2001 Dodge Ram 2500 141k 1979 300D 234k (sold) 1984 300D "Astor" 262k(sold) Mercedes How-To and Repair Pictorials I love the smell of diesel smoke in my hair |
Bookmarks |
|
|