|
|
|
#1
|
||||
|
||||
'85 300td coolant system routing
HI everyone,
i'm currently installing a frybrid WVO kit on my 300td. (w/ A/C) The instructions say to 'T' into the coolant system at the heater core supply and return lines. I'm pretty sure we have found both of these lines ( the two collant lines going through fire near the top). I'm a little unsure which is return and which is supply. Can somebody please help me out, unfortunately the repair manual I bough t does not include a cooling system diagram. Are there any oinline diagrams that anyone knows about. Thanks a lot, hopefully the rest of the install goes well. Also does anyone have experinece/ideas about a good way to route my fuel/coolant lines under the car back to the new WVO tank in the rear (behind rear axel). Thanks a lot Brett |
#2
|
||||
|
||||
I think the supply line is the one coming from the auxiliary water pump, low down on the right (passenger) inner fender.
__________________
"Buster" in the '95 Our all-Diesel family 1996 E300D (W210) . .338,000 miles Wife's car 2005 E320 CDI . . 113,000 miles My car Santa Rosa population 176,762 (2022) Total. . . . . . . . . . . . 627,762 "Oh lord won't you buy me a Mercedes Benz." -- Janis Joplin, October 1, 1970 |
#3
|
||||
|
||||
just though I would bump this up to the top, any insights. Thanks
|
#4
|
|||
|
|||
Here's a diagram of the cooling system:
http://mb.braingears.com/123_DISK2/program/Engine/617/20-005.pdf |
Bookmarks |
|
|