|
|
|
|
|
|
|
#1
02-16-2007, 01:36 PM
|
|||
|
|||
door pocket velour trim panel
I posted this over in detailing about a week ago but haven't heard any ideas.
The velour-covered panel that attaches to the bottom of the door pockets has come loose and is flopping around. Upon investigation, several of the locking "nubs/posts" on the back of the panel have broken off. Any ideas on how to reattach it to near original looks? So far, I've considered epoxy for the nubs/posts or velcro but am not sure if either will last at all.
__________________
Sam 84 300SD 350K+ miles ( Blue Belle ) 
|
|
#2
02-16-2007, 02:20 PM
|
||||
|
||||
|
go to a junkyard, and get the rear trim off of a chevy astro van back window interior trim. it uses a very hard plastic velcro that is glued on, pop off the velcro and use it.
John
__________________
John HAUL AWAY, OR CRUSHED CARS!!! HELP ME keep the cars out of the crusher! A/C Thread "as I ride with my a/c on... I have fond memories of sweaty oily saturdays and spewing R12 into the air. THANKS for all you do! My drivers: 1987 190D 2.5Turbo 1987 560SL convertible 1987 190D 2.5-5SPEED!!!  1987 300TD 2005 Dodge Sprinter 2500 158"WB 1994GMC 2500 6.5Turbo truck... I had to put the ladder somewhere!
|
|
#3
02-16-2007, 03:05 PM
|
||||
|
||||
|
I'd buy two new matching ones from the friendly local MB dealer.
 Epoxy doesn't stick to plastic, try some plastic model cement.
__________________
2016 Corvette Stingray 2LT 1969 280SE 2023 Ram 1500 2007 Tiara 3200
|
 |
| Bookmarks |
|
|
Hybrid Mode
