|
|
|
#1
|
||||
|
||||
Need Torque Spec for Suspension Rebuild
Hello All,
I am getting ready to rebuild my suspension on my 300D and I need the torque spec for the replacement of the following pieces. Center link Steering Damper Tie rod Assembly Idler Arm Rebuild Lower control arm Lower ball joints Guide rod mount - Lower control arm end Guide rod mount- chassis end Upper control arms Upper control arm sway bar bushings Shocks Thanks in advanced
__________________
1983 123.133 California - GreaseCar Veg System |
#2
|
|||
|
|||
It's all in the Mercedes Service Manual for W123, available on CD from your dealer or by calling 1.800.for.merc.
__________________
Kent Christensen Albuquerque '07 GL320CDI, '10 CL550. '01 Porsche Boxster Two BMW motorcycles |
#3
|
||||
|
||||
Yes, I know that. But If someone has it handy. It would be much appreciated!
__________________
1983 123.133 California - GreaseCar Veg System |
#4
|
||||
|
||||
It's a lot of work looking all that up from a cd why don't you go out and get a Haynes manual?
__________________
1984 300SD Turbo Diesel 150,000 miles OBK member #23 (\__/) (='.'=) This is Bunny. Copy and paste bunny into your (")_(") signature to help him gain world domination |
#5
|
||||
|
||||
You guys kill me! Again, if it was HANDY post it.... If not I'll get it from the other sources.
__________________
1983 123.133 California - GreaseCar Veg System |
#6
|
||||
|
||||
All Ft lbs. Pitman arm, center link?..22mm nut 103 to 132,24mm nut 118 to 147...track rod and drag link bolt 26...track rod clamp bolt 15...steering gear bolts 51-59...steering arm nut 59...steering damper bolt 33...steering wheel nut or screw59...steering shaft coupling bolt 18. This is from Haynes.
__________________
83 SD 84 CD |
#7
|
||||
|
||||
Quote:
__________________
1983 123.133 California - GreaseCar Veg System |
#8
|
||||
|
||||
more specs
All Nm now, this from the MB Service Manual. Shocks, bottom bolts tighten with loctite 20, top the rubber bushing will need to be squeezed a little, should have instructions with new shocks. UCA hex bolt bearing to front end, 80...hex nut of guide joint, 40...hex bolt of UCA support to torsion bar, 65...tie rod ends, can't find, I would go with 80, same as steering knuckle.
__________________
83 SD 84 CD |
Bookmarks |
|
|