|
|
|
#1
|
|||
|
|||
300CD Valve Cover Gasket
1985 - 300CD Turbo.
I recently removed the valve cover for polishing. I installed the valve cover using a new M/B gasket. Since the installation I have noticed oil weeping form around the last three injectors. The flow is slight but before no leak. So I went back and re-torqued the V cover, seems to be better but not dry. Question: Is there any trick/sealant to installing the cover? Thanks very much, Zill. |
#2
|
||||
|
||||
no sealant.. just 11 ft lbs of torque on each bolt... do it in an X pattern when tightening.. if you are up to it remove the valve cover and the gasket.. and put on a known flat surface to check for warping.
|
#3
|
||||
|
||||
That gasket is easy to get out of position during installation, carefully inspect to make sure it's on properly, good luck.
__________________
83 SD 84 CD |
Bookmarks |
|
|