|
|
|
#1
|
||||
|
||||
motor shake
Hello Peepz
my car has a problem it shake very much when the motor is hot you can see is in the film what is the problem ? the car is an w123 turbo diesel from 1982 http://nl.youtube.com/watch?v=fmpazrg5akY |
#2
|
||||
|
||||
We can't see if it also does this at faster RPM??
How old are the engine mounts and shocks? (or have you ever replaced them?)
__________________
1987 300D (230,000 mi on a #14 head-watching the temp gauge and keeping the ghost in the machine) Raleigh NC - Home of deep fried sushi! |
#3
|
||||
|
||||
Quote:
when motor cold it shakes not mount and shocks are good the car is from 1982 and it has 275.00 miles i live in holland i have buy the car from texas |
#4
|
|||
|
|||
I find it strange that you had to come to texas from holland to find a w123. Probably your rack dampner bolt or out of balance injectors.
__________________
|
#5
|
||||
|
||||
Quote:
ik have buy the carr on ebay im not come to texas |
#6
|
||||
|
||||
May not be the rack damper bolt, make sure the injectors are working properly, and all are getting fuel.
__________________
83 SD 84 CD |
#7
|
||||
|
||||
from what i can see it looks like only the air filter housing is moving, not 100% sure but that looks like it. If this is the case then the air filter housing bracket would need to be replaced.
|
#8
|
||||
|
||||
i have replace 3 filter housing brackets
|
#9
|
|||
|
|||
Its obvious that that car has a bad case of the shakes. Not just the air cleaner bracket.
__________________
|
#10
|
||||
|
||||
anymore input on this? I did a motor swap recently. The first drive, the car idled fine. After that it has the same exact shake. Not a vibration, just a big rocking movement. It only happens when warm. Not the fuel, i checked. Not the filters, i checked. I checked my valves this afternoon and all are in adjustment. What the hell? The only thing I can think of is an injector.
__________________
1981 300SD 512k OM603 |
#11
|
|||
|
|||
I just found out from an injector rebuilder that some times the shake comes from the check valve at the top of the ip where it comes out to the steel lines.
|
#12
|
||||
|
||||
mbonly2,
Did he tell you whether or not you could easily replace those check valves with valves from another pump? Otto '79 240D 4spd |
#13
|
||||
|
||||
what check valves?
__________________
1981 300SD 512k OM603 |
#14
|
|||
|
|||
Start with the easy stuff before you get concerned about injectors.
Most rocking, shaking, rattling, and rolling engines are due to the following: - Needs valve adjustment - Worn engine mounts - Rack dampener bolt needs to be adjusted Adjust the valves and check motor mounts before you do anything else. |
Bookmarks |
|
|