![]() |
|
|
|
#1
|
||||
|
||||
DIY: W123 console shifter bushings
This is a guide for how to replace the 2 bushings inside the console. I didn’t replace the other 2 bushings on the rod going to the tranny because they were still good.
You’ll need: Plilips head screw driver Flat head screw driver Snap ring pliers ¼ 10mm socket ¼ ratchet and extension 15mm wrench Wheel bearing grease 2 bushings 115 267 12 50 1. Push the metal tab down a remove the ashtray: ![]() 2. Remove both Philips head screws: ![]() 3. Pull the bracket out and unplug the connector: ![]() 4. Pull the front part of the wood up and slide back then unplug all switches: ![]() 5. Pry out the shifter light: ![]() 6. Remove all 3 10mm bolts that hold the shifter gate in place: ![]() 7. Twist the shifter gate to the side and use a 15mm wrench and loosen the lock nut and then finish turning the shifter knob counter clock-wise until it is off: ![]() Last edited by 79Mercy; 01-04-2009 at 07:21 PM. |
Bookmarks |
|
|