|
|
|
#1
|
|||
|
|||
rear bumpers w123 wagon same as a w123 sedan?
In regards to rear bumpers, is the w123 300TD wagon the same as a w123 240D sedan?
|
#2
|
|||
|
|||
I would say that the mounting holes may be the same but the wagon bumpers have pieces cut out on each lower side for the back-up lights.
|
#3
|
||||
|
||||
The bumper itself is different. Like stated above the wagon bumpers have notches for the reverse lights.
__________________
Andrew '04 Jetta TDI Wagon '82 300TD ~ Winnie ~ Sold '77 300D ~ Sold
|
#4
|
||||
|
||||
I've seen a wagon bumper installed on a sedan, it fits the same and works fine even if the backing lights aren't connected to anything but you wouldn't want to put a sedan bumper on a wagon (unless you wanted a car without the proper backing lights!)
__________________
'95 E320 Wagon my favorite road car. '99 E300D wolf in sheeps body, '87 300D Sportline suspension, '79 300TD w/ 617.952 engine at 367,750 and counting! |
#5
|
|||
|
|||
I replaced the mangled OE rear bumper on my Euro '84 30TD, with my spare US 5-mph sedan bumper. A PO already installed a US bumper in front, and at the time I wasn't able to find a matching rear wagon bumper. I modified/repaired the already damaged & mismatched backup lamps to bolt under the sedan bumper (though I was later told by the inspector that backup lights aren't even required in Virginia)
They do hang down some, but don't look too bad. I just have to be carefull not to back into high curbs and other obstacles. Happy Motoring, Mark
__________________
DrDKW |
#6
|
|||
|
|||
I had an 83 TD and I still have a 84 300D
the bumpers do not have the same braces that attach under. The D is designed to attach a little more narrow if I remember correctly. And, they are at a different angle. I am sure that w/ a little welding that you could have it on, no problem..
__________________
http://www.libertyagrifuels.com 1984 300D Turbo 1980 300SD Sold 1983 300TD Sold Dagger 16 ft. Legend Canoe (for the weekends) Marin Northside Trail Mtn. Bike |
#7
|
|||
|
|||
The W123 sedan bumper I installed fit the mounting points of my'84 TD perfectly. And though my wagon was originally a Euro model, it already had the sockets for the US bumper-shocks.
Happy Motoring, Mark
__________________
DrDKW |
#8
|
||||
|
||||
Quote:
you can use a TD bumper on a D, vice versa, and you can put a TD hitch on a D(the hitch which mounts with the bumper mounts.)
__________________
1984 123.193 372,xxx miles, room for Seven. 1999 Dodge Durango Cummins 4BTAA 47RE 5k lb 4x4 getting 25+mpgs, room for Seven. |
#9
|
|||
|
|||
Quote:
This spring I was lucky to find an '83 Euro-wagon in the Virginia Beach Pick-N-Pull. For $100 got the complete set of Euro-bumpers,with all the skirts, boots, brackets and rear lights, including the correct bumper-mounted red Euro foglamp. So my wagon can eventually be converted back to it's original form. Happy Motoring, Mark
__________________
DrDKW |
#10
|
||||
|
||||
how is that?
__________________
http://superturbodiesel.com/images/sig.04.10.jpg 1995 E420 Schwarz 1995 E300 Weiss #1987 300D Sturmmachine #1991 300D Nearly Perfect #1994 E320 Cabriolet #1995 E320 Touring #1985 300D Sedan OBK #42 |
#11
|
|||
|
|||
Recently on another thread, there were a number of aftermarket hitches discussed, sold to fit the W123 with 5-mph bumpers.
The best design bolted to the six bumper-shock studs, with reinforcing extensions that went forward and attached to the unibody frame rails. Happy Motoring, Mark
__________________
DrDKW |
Bookmarks |
|
|