|
|
|
#1
|
|||
|
|||
Advice on repair manual
For the 75 300D, need to learn about the IP for seals and potential R & R. Does the manual at the link below contain such info?
http://www.mercedesmanuals.com/Mercedes_Benz_W_114_W_115_Shop_Manual_p/w114-115.htm |
#2
|
||||
|
||||
Quote:
Here is where to get it. It covers the complete Car with the exception of rebuilding Turbos and Transmissions. Yes, it tells you how to chang the Delivery Valve seals. http://www.classictechlit.mbusa.com/MB/product.asp?catalog%5Fname=Retail&category%5Fname=1009%28ClassicTechLit%29&product%5Fid=QL%2D6516%2D0507%2D02%28ClassicTechLit%29 However, the Do It Youself (DIY) section instructions on this forum are a littler clearer than the Service Manual Instructions for changing the Delivery Valve Seals. But, the $27 CD set will easily save you more money than the initial cost.
__________________
84 300D, 82 Volvo 244Gl Diesel |
#3
|
||||
|
||||
There are only Copper Crush Washers under the Delivery Valves on your Fuel Injection Pump and the only other seals are a few O-rings on the Throttle Shaft and maybe a few other areas.
No one but Bosch supplies information on rebuilding the Fuel Injection Pumps. To get that information you would have to luck out and find some "Film Fisch" selling on eBay or become a licensed Bosch Dealer. The Fuel Injection Pump Seldom Causes A problem. When it does most buy a used one to replace it.
__________________
84 300D, 82 Volvo 244Gl Diesel |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|