Passenger side front manual window.
Will roll down without a problem. When rolling up, the window goes up crooked, leaning toward the front- to get it to go up, you have to keep pressing the glass back as you go up.

Took the panel off and checked it out. When the window is all the way down, the front of the window(towards the front of the car) isn't in the track- there's better than a half inch gap between the bottom front of the window and the bottom of the front guide rail (track).

When the window is cranked up, the front of the window doesn't go into its guide rail (track) at all- it has to be guided up by hand.

I saw broken glass in the bottom of the door, so I'm assuming this glass has been replaced at some point.

I took the entire glass out of the door thinking that if I can move the glass forward in the bracket that the glass sits in (at the bottom of the glass), then it might sit in the front guide rail (track) at the bottom- maybe that will help guide it the whole way up.
I'm having a problem moving that bracket the glass is sitting in- using wood block and rubber mallet.....it's not budging- do you think I'll have to remove that bracket to get it to move? Do you think this will help?

Here's the numbers off the glass- just in case I'm dealing with the wrong size glass for that door-
Sekurit-1F
D287
Dot27 M53 A S2
DGM 35636
ITP GSE 433 000

Thanks in advance for the help.
Jay

__________________
Wordmanjay
Tribetown, Ohio