Torque converter?
 

When I bolted my flywheel to the torque converter I could not find any torque #s for that, so I tightened them up pretty good but not too tight. I have been worried that they might come back out, should I put some lock tight on those bolts? It would make me feel better.

Last time I did that job I didn't torque to a spec. I just made them pretty tight. In the entire 0 mile life of the repair (it turns out I installed a dud transmission), there were no problems with the torque converter bolts.

From the OM602 "Instructions"
 

Hexagon bolts for torque converter driver plate
Unscrew, screw in,
tightening torque 42 Nm.

This sounds like the making of a poor car-jock joke,

Q: How tight do you torque a torque converters bolts?

A: No soap, radio!!

I even have the Service Manual and I could not find it, Thankyou.

Answer
 

transmission tourque figures
http://www.peachparts.com/shopforum/showthread.php?t=256787

FIY: It is in WIS, document RA27.03-7-77A6-00X and RA27.00-7-2206-00Z







.