|
|
|
#1
|
|||
|
|||
Rack Dampener O-Ring
I was wondering if anybody might have the part number for the o-ring that goes on the rack dampener bolt. My new bolt did not come with one and I'd like to replace it along with the bolt.. Thanks in advance!
|
#2
|
||||
|
||||
On a 617, 002 997 85 45.
__________________
83 SD 84 CD |
#3
|
|||
|
|||
Thanks for the response...I really appreciate the help. It is for an '82 300d-turbo. I'm having a little trouble finding that part number online. Is there anything special about that particular o-ring besides the size? If not, would anybody happen to know the correct size? Thanks again!
After seeing how brittle the O-rings were that I replaced on the pipe that is part of the oil filter housing cover, I'd like to have one on hand for this bolt when I pull it out. |
#4
|
|||
|
|||
I got mine from the dealer for $7.
I didn't notice anything special about it. It seemed to be a regular o-ring. Even if my memory fails me and it's a d-ring or a short tadpole ring gasket you should be able to get away with a simple o-ring from McMaster of the same diameter. You should be fine with just Buna-N at A70 or A50. Check just find the approximate size. http://www.mcmaster.com/#o-rings/=e5d3lr
__________________
Onus probandi incumbit ei qui dicit, non ei qui negat I recondition w123/w126/w124/w140/r107/r129/ steering boxes! 1984 300D "Elsa" odo reset 6/2011 147k 1983 300TD "Mitzi" ~268k OM603 powered 1995 E300 "Adelheid" 262k [Sold] |
#5
|
||||
|
||||
Dealer only item, it may be 8mm x 12 mm.
__________________
83 SD 84 CD |
Bookmarks |
|
|