On my 85 300D I removed the front bumper right side rubber end cap so I could re-attach the rubber bumper strip which was coming loose. To get the end cap off, I pushed it back off of its bracket. To get it back on, it looks like I could struggle and push it back on with maybe some Vaseline, but I am wondering if it would be better to remove the sheet metal bracket, put the end cap on the bracket and then attach the bracket back onto the car. The only thing that is keeping me from jumping into this is that the bracket attaches with one bolt and nut, and also one fastener that looks like a plastic piece that goes through the fender. It is coated with tarry stuff on the back side so I cannot tell what the back of the fastener looks like. I suspect that I might break it if I try to remove it. Is this the way the bracket came from the factory or did someone use some other kind of fastener at some point?

Thanks for any suggestions.

Richard

__________________
85 300D 75K Anthracite Grey 0-60 in 13 seconds **For Sale**
84 300D 333K Black (The Velveteen Rabbit) 0-60 in 14 seconds
00 Toyota Sienna 208K (Sold)
15 Subaru Outback 43K
11 Subaru Outback 67K
98 Ford Taurus 100K (Gertie - Was Grandma's - drove it to church and shopping - really) Daughter's car now.
30 Model A Ford 2 Door Sedan (Sold) 0-60 in . . . Never reached 60