|
|
|
#1
|
|||
|
|||
4 Way Accessory Vacuum T on OM603
Traced down vacuum issue to the part in the attached picture. It branches off the vacuum accessory port to 4 vacuum lines. I tested this part with my mity vac and it seems that when you plug all ports except one that it only holds a vacuum on one port.
Can't see any rips or tears in this so am a bit perplexed. Is this normal or is this part bad. Part number is 6010780045. Thanks, Steve |
#2
|
|||
|
|||
If you don`t see any cracks in the rubber fitting, it could be where the plastic vacuum line slips into the rubber. The rubber could be dried out where it doesn`t fit tight enough.
Use some small Zip Ties to make it fit tighter, then check for a leak. Charlie
__________________
there were three HP ratings on the OM616... 1) Not much power 2) Even less power 3) Not nearly enough power!! 240D w/auto Anyone that thinks a 240D is slow drives too fast. 80 240D Naturally Exasperated, 4-Spd 388k DD 150mph spedo 3:58 Diff We are advised to NOT judge ALL Muslims by the actions of a few lunatics, but we are encouraged to judge ALL gun owners by the actions of a few lunatics. Funny how that works |
Bookmarks |
|
|