|
|
|
#1
|
|||
|
|||
Washer Reservoir Lid Won't Stay in Place
On my 98 E300D, there's the lid to the washer reservoir that you open to put in fluid. But that lid in turn is connected to a larger plastic piece, a larger lid, through which the heating tubes go. That larger piece won't connect securely to the reservoir....it keeps wanting to lift up. Any ideas as to how I can get it to stay in place? I could use some sort of epoxy, of course, but that seems unnecessarily permanent.
__________________
14 E250 Bluetec "Sinclair", Palladium Silver on Black, 153k miles 06 E320 CDI "Rutherford", Black on Tan, 171k mi, Stage 1 tune, tuned TCU 91 300D "Otis", Smoke Silver, 142k mi, wastegate conversion 19 Honda CR-V EX 61k mi Fourteen other MB's owned and sold 1961 Very Tolerant Wife |
#2
|
||||
|
||||
Let me know what you find, I'm having the same problem.
-J
__________________
1991 350SDL. 230,000 miles (new motor @ 150,000). Blown head gasket Tesla Model 3. 205,000 miles. Been to 48 states! Past: A fleet of VW TDIs.... including a V10,a Dieselgate Passat, and 2 ECOdiesels. 2014 Cadillac ELR 2013 Fiat 500E. |
#3
|
||||
|
||||
On the w123 you can buy the lid separately. (I did, once, some time ago tho.) Don't know about other models.
__________________
Mac 2002 e320 4matic estate│1985 300d│1980 300td Previous: 1979 & 1982 & 1983 300sd │ 1982 240d “Let's take a drive into the middle of nowhere with a packet of Marlboro lights and talk about our lives.” ― Joseph Heller, Catch-22 |
#4
|
|||
|
|||
Using some epoxy would certainly do the trick....would I have any reason to regret that?
__________________
14 E250 Bluetec "Sinclair", Palladium Silver on Black, 153k miles 06 E320 CDI "Rutherford", Black on Tan, 171k mi, Stage 1 tune, tuned TCU 91 300D "Otis", Smoke Silver, 142k mi, wastegate conversion 19 Honda CR-V EX 61k mi Fourteen other MB's owned and sold 1961 Very Tolerant Wife |
#5
|
||||
|
||||
I wouldn't epoxy the lid down. It would make it much more difficult to remove the reservoir for cleaning or if you have to access the fuel system. Pulling the washer tank allows access to the lift pump, most of the fuel lines, and the shutoff valve without having to remove the intake manifold.
__________________
The OM 642/722.9 powered family Still going strong 2014 ML350 Bluetec (wife's DD) 2013 E350 Bluetec (my DD) both my kids cars went to junkyard in 2023 2008 ML320 CDI (Older son’s DD) fatal transmission failure, water soaked/fried rear SAM, numerous other issues, just too far gone to save (165k miles) 2008 E320 Bluetec (Younger son's DD) injector failed open and diluted oil with diesel, spun main bearings (240k miles) 1998 E300DT sold to TimFreeh 1987 300TD sold to vstech |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|