I've been getting water into my trunk, so I took my seal entirely off, which was a very easy project. They have square pegs of sorts holding the plastic part in at the bottom and sides of the trunk. Just get a small screwdriver and work those out so you can remove the plastic part.
I cleaned the gunk out of the seal and the water channel. I'll let that dry well before putting it back on.
The question I have is, am I supposed to use a gasket sealant of any type? The seal as it was came right out. I've seen some videos on youTube of other cars where they have to use a chemical gasket remover to get the gasket out. Mine came out real easily, so I don't think they used a sealant at all from the factory.
Just wondering if I'm supposed to put any on or not. The gasket itself holds in nice and firm all on its own.
jeff 1991 300d, 203k