|
|
|
#1
|
|||
|
|||
Spring has sprung!
And the springs on my 79 240D are showing movement up around the spring pad. The pads on the rear of the car have 3 bumps (nubs, burrs, zits, nodules, whatever they are called) and I want to replace these while I am replacing the shocks. I am hoping this is just the pads.
So-what thickness do I order? Thanks! snapped_bolt
__________________
'81 240D For now, a good place to borrow new parts '80 300TD Probably will be put back into service! '79 240D BACK IN SERVICE SINCE 09/16; limited use, oil leak. Guide pin r/sealed/replaced. Still a leak. Front crank seal.... |
#2
|
|||
|
|||
I think one who is banned did some testing and has info in the archives. I dropped down in thickness on the front of an SD. I think the thinner new pads were about the same as the compressed old thicker pad. I measured height at he wheel well arch.
__________________
85SD 240K & stopped counting painted, putting bac together. 84SD 180,000. sold to a neighbor and member here but I forget his handle. The 84 is much improved from when I had it. 85TD beginning to repair to DD status. Lots of stuff to do. |
Bookmarks |
|
|